Wood Max Express Power

Cartridge 380 g

Extremely strong, fast (firm to touch in 30 minutes), waterproof (D4, according NEN-EN 204 standard) and gap filling, wood construction adhesive based on SMP polymer.

Wood Max Express Power

Description

Properties

  • Very fast (firm to touch in 30 minutes)
  • Extremely high final bond strength (110 kg/cm²)
  • Waterproof (D4)
  • PU & Solvent free
  • Very good filling capacity (up to 4 mm)
  • Can be scraped immediately
  • Permanently flexible
  • Paintable
  • All-weather resistant
  • UV resistant
  • Thixotropic
  • Good standing power; does not drip
  • ATG certified (Cert. no. ATG 3125) ‘Adhesives for non-supporting wooden structures’
  • KOMO certified (Cert. no. 32394) ‘Adhesives for non-supporting applications’
  • Innovative formula: patent pending

HALLMARKS

  • 48_3.png
  • 48_2.png
  • 48_1.png
Go to top

Applications

Suitable for:

  • For waterproof (D4) (surface) bonding of most types of wood (less suitable for chemically treated wood) and many other building materials. For non-supporting wooden structures. Very suitable for poorly fitting joints. Not suitable for PE, PP, PFTE and PA (nylon).
  • D4: Interiors where flowing water or condensation are present over long periods on a regular basis. Exteriors exposed to the influences of the weather, providing effective protection for bonded wood.
Go to top

Handling

Before use:

Working conditions

The ambient temperature, the adhesive and the materials to be bonded should not be less than +5°C. Wood humidity must preferably be between 10% and 18% (max. 25%).

Surface requirements

Surfaces must be clean, dust- and grease-free. Degrease oily types of wood with Griffon Cleaner. Roughen non-porous materials.

Preliminary surface treatment

Surfaces must be clean, dust- and grease-free. Degrease oily types of wood with Griffon Cleaner. Roughen non-porous materials.

Tools

Sealant gun, glue spreader, brush or roller.

During use:

Directions for use

Apply the adhesive evenly directly from cartridge on both sides (for the best result) with a sealant gun. Where needed spread further with sealant gun, glue spreader, brush or roller. Ensure adequate layer thickness. Assemble joint within 5 minutes and fixate for at least 30 min. No pressing. If clamped, use a limited pressure to avoid too much adhesive to be pushed out of the bond.

After use:

Stains/residue

Remove wet adhesive residue immediately with Griffon Cleaner. Dry adhesive residue can only be removed mechanically.

Storage conditions

Store in properly sealed packaging in a dry place at between +5°C and +25°C.

Go to top